When it comes to installing Weathershields on your vehicle, it's important to follow the correct steps to ensure a proper fit and functionality. Here is a step-by-step guide on how to install Weathershields(No-clip version) the right way.
1.Test for Proper Fit
Before applying any adhesive, test the fit of the weathershields on your vehicle to ensure they align properly and do not obstruct the windows or doors.
2. Clean the Surface
Thoroughly clean the area where the weathershields will be installed to ensure a secure fit. Use a mild soap and water solution to remove any dirt, grime, or residue.
3. Apply Adhesive (optional)
Adhesive promoter can helps sticker work better. Apply dot of promoter directly on adhesive tape or surface of vehicle where you will stick weather shields on.
4. Install the Weathershields
Tear off approximately 5-10cm of the adhesive tape at each ends of the shields. Make sure they are aligned correctly and securely attached. Once the adhesive tape is applied, tear off the remaining adhesive tape in the middle. Press down firmly to ensure a strong bond.
5. Test and Set
Once the weather shields have set, test the functionality by opening and closing your windows and doors to ensure they operate smoothly and without obstruction.
Don't wash the car for 48 hours after installation to allow the weathershields to set and cure.
By following these steps, you can successfully install weathershields on your vehicle and enjoy added protection and ventilation in any weather conditions. Remember to always refer to the manufacturer's instructions for specific guidance on your particular weathershields model.