Thank you for choosing AUSGO 4WD Accessories. This bonnet protector is designed to safeguard your vehicle’s bonnet from stone chips, road debris, and insects while adding a sleek and protective look. Please read the following instructions carefully before installation.
This installation guide includes two methods.
- Clip-On Bonnet Protector
- Adhesive Tape Bonnet Protector
Please follow the steps corresponding to the version you purchased.
Part A: Clip-On Bonnet Protector
Step 1: Check Fitment
Hold the protector against the bonnet edge to confirm proper alignment.
Step 2: Check Accessories
Lay out all included accessories to ensure nothing is missing.
(Please note that included accessories may vary between models—refer to the printed instructions in your package for the exact contents.)
Step 3: Clean Bonnet Surface
Thoroughly clean the front edge of the bonnet, removing all dust, dirt, and debris.
Step 4: Assemble Bonnet Protector
- If you purchased a 3-piece protector, assemble the pieces first.
- Connect the ends and secure them with the supplied screws.
Step 5: Prepare Mounting Brackets
- Attach the U-shaped brackets to the back of the protector.
- Insert the round washers and nuts through the pre-drilled holes.
Step 6: Install Protector
- Align the protector with the bonnet, ensuring the U-shaped brackets match the bonnet’s holes underneath.
- Carefully insert secure them with the No.4 screws to finalize the installation (do not overtighten).
Step 7: Final Check
Ensure all clips and buckles are secure; protector sits flush on bonnet.
Part B: Adhesive Tape Bonnet Protector
Step 1: Check Fitment
Hold the protector against the bonnet edge to confirm proper alignment.
Step 2: Clean Bonnet Surface
- Thoroughly clean the front edge of the bonnet, removing all dust, dirt, and debris.
- Ensure the surface is completely dry before proceeding.
Step 3: Apply Adhesion Promoter (Optional)
For stronger adhesion, apply adhesion promoter to the installation area.
Step 4: Position and Attach
- Peel back about 2 inches of liner from each tape section and fold it back to create a pull tab.
- Carefully align the protector in place. Starting from the center, slowly peel the liner while applying gentle, even pressure.
- Repeat until all liners are removed.
Step 5: Press Firmly
Apply firm pressure along all taped edges to ensure full contact and adhesion.
Step 6: Avoid Moisture
Do not wash or expose the protector to water for 72 hours after installation.
After Installation
- Recheck the bonnet protector after a short drive to ensure all fittings remain secure.
- For adhesive type, maximum bonding strength is achieved after 72 hours.
- Clean with mild soap and water; avoid harsh chemicals.
Note
- Installation is best done in a clean, dry environment.
- If unsure, professional installation is recommended.
Features of AUSGO Bonnet Protector
Crafted from premium, UV-resistant acrylic, the AUSGO Bonnet Protector is built to withstand harsh weather and long-term exposure without fading or cracking. Its vehicle-specific design ensures a seamless fit, offering reliable protection against stone chips, road debris, and insects while preserving the clean lines of your bonnet. Easy to maintain and simple to clean, it not only keeps your vehicle safe but also adds a stylish finishing touch that complements its overall look.
With proper installation, your AUSGO bonnet protector will deliver long-lasting performance and style, ensuring your vehicle stays protected on every journey.